| Supply Voltage | 12 - 24 VDC |
| Supply Variation | -10% to +25% |
| Power Consumption (Max.) | 2 W |
| Operation Mode | Raw, Telnet |
| Configuration Management | HTTP Web Server and Application software |
| Number of Serial Ports | 2 |
| Serial Interface | Port1: Screw terminals for RS232, RS422 and RS485 interface, Port2: RJ11 for RS232 Interface |
| Signals | RS232 : RXD, TXD, GND, RS422 :TX+, TX-, RX+, RX-, GND, RS485 : TX+ (D+), TX- (D-), GND |
| Serial Interface Selection | For Port1: Mode selection using RST switch with Mode LED indication |
| Serial Communication Parameters | Baud Rate : 300bps to 115.2Kbps, Data Bits : 7,8 ; Flow Control : None
, Parity : Odd, Even, None, Stop Bits : 1,2 |
| Fail safe resistor | 4K7 Resistor Pull up ( TX+) & Pull Down (TX-) on BUS |
| Terminating Resistor | Connect externally if required |
| Isolation | Isolation 2 KVrms |
| Port | RJ45, Ethernet 10/100 Mbps |
| LAN Isolation | 1.5KVrms magnetic Isolation |
| Network Protocol’s Supported | Protocols for Communication : Raw, Telnet-RFC2217, Standard Protocols used : HTTP, DHCP, AUTOIP, UPnP, TCP, UDP, IP, ARP, ICMP, Protocols used for firmware updating : BOOTP, TFTP |
| LAN Interface Isolation | 1.5KVrms magnetic Isolation |
| Configuration Software | Windows Based Software to Configure Ports as well as Selection of Protocol Driver |
| Reset | Front Panel recessed , Loads Default Factory Settings & Serial Mode selection |
| LED Indications | Serial TX and RX, LAN: LINK and Activity, Power ON, Error, Mode Selection Indication LED |
| Operating Temperature | 0°C to + 55°C |
| Enclosure | Flame Retardant UL94-V0 |
| Dimension (W x H x D) (in mm) | 72 X 90 X 58 |
| Weight (unpacked) | 185 g |
| Mounting | Base / DIN Rail |
